We have been using a static type checker (pyright) for a long time, but its
check was not yet a prerequisite for passing the quality gate. It was checked
in the CI, but the error messages were only logged.
As is always the case in life, with checks that you have to do but which have no
consequences; you neglect them :-)
We didn't activate the checks back then because we (even today) have too much
monkey patching in our code (not only in the engines, httpx and others objects
are also affected).
We want to replace monkey patching with clear interfaces for a long time, the
basis for this is increased typing and we can only achieve this if we make type
checking an integral part of the quality gate.
This PR activates the type check; in order to pass the check, a few typings
were corrected in the code, but most type inconsistencies were deactivated via
inline comments.
This was particularly necessary in places where the code uses properties that
stick to the objects (monkey patching). The sticking of properties only happens
in a few places, but the access to these properties extends over the entire
code, which is why there are many `# type: ignore` markers in the code ... which
we will hopefully be able to remove again successively in the future.
Signed-off-by: Markus Heiser <markus.heiser@darmarit.de>
settings.yml:
* outgoing.networks:
* can contains network definition
* propertiers: enable_http, verify, http2, max_connections, max_keepalive_connections,
keepalive_expiry, local_addresses, support_ipv4, support_ipv6, proxies, max_redirects, retries
* retries: 0 by default, number of times searx retries to send the HTTP request (using different IP & proxy each time)
* local_addresses can be "192.168.0.1/24" (it supports IPv6)
* support_ipv4 & support_ipv6: both True by default
see https://github.com/searx/searx/pull/1034
* each engine can define a "network" section:
* either a full network description
* either reference an existing network
* all HTTP requests of engine use the same HTTP configuration (it was not the case before, see proxy configuration in master)
